Proizvedeno u : Aziji

SmartRF04EB CC1110 CC2530 ZigBee Emulator USB Downloader Buffer SmartRF 0047

Description:

The CC Debugger is primarily used for debugging and programming the flash on CCxxxx 8051-based System-on-Chip (SOC) devices from Texas Instruments. CC Debugger also supports CCxxxx RF transceivers. In addition, CC Debugger is used for configuring the CC85xx devices with Pure Path Wireless Configurator.

Compatible with the original TI CC Debugger

Supported Operating Systems: Windows 2000, Windows xp sp2/sp3, Windows Vista 32bit, Windows 7 32bit

Target voltage: 1.2V~3.6V

Capable of powering the target board from the debugger

Operating temperature: 0Â ° C~85Â ° C

Supported Software

IAR Embedded Workbench For C8051

SmartRF Flash Programmer

SmartRF Studio

SmartRF Packet Sniffer

Pure Path Wireless Configurator

Connects to PC

Computer connection via USB interface

Connects to target board

Target board connection via 10-pin IDC connector (2x5 2.54mm pitch)

LED Status

OFF: The debugger has no power or there is no valid firmware on the debugger.

AMBER (BOTH LEDS ON): The debugger is powered, but there is no valid firmware.

RED LED BLINKING: The Debugger is in Boot Recovery Mode.

RED LED ON: No device detected. This might be due to old firmware on the CC Debugger, or a problem with the hardware connection (make sure the target board is properly powered and connected correctly).

GREEN LED ON: The target device has been properly detected. It is possible to start programming/ debugging.