Proizvedeno u : Aziji

1 . Power consumption.OurWIFIParameter module is powered3.3VPowered by,70mA-200mAPower consumption is far below normal marketWIFIModule.
2 . Design enhancements .Adopt a new4Layer design , compared to previous2Plates , stability and anti-interference ability , better quality !
3 .AP + STA Mode.AT + STACan coexist ,Meet most customer requirements.

4 .Various versions of software support.We offer our customers a variety of test software for free , such asPCClient software , Android software.
5 .Strong supply capacity.Never out of stock, long-term stability of bulk supply worries, long-term module1000Sets of inventory, less than2000Piece usually2Week delivery.
6 .Stable performance.OurWIFIModules have been listed a year , after a number of technical personnel improvements versions rapid iteration . Stable performance, stand the test of the market .
7 .Free and open .Full liberalizationSDK,apiComplete. You can achieve the aspirations of secondary development .
8 .FCC / CEAuthenticate.Module byFCC,CECertification,MACAddress has been burning inside the module , without the customer to pay for another .
WIFIModule Quality Assurance:

1,ByCEAndFCCAuthenticateThis is the electronic products into the EU and the United States access to proven , is a sign of quality products .

2After high and low temperature testing,-20°-80°Industrial Operating ambient temperature range.

3, Each with a specialized test equipment products are rigorously tested .
The module is a 12-foot clock with 4 points of positive digital (0.36 inches) display module driver IC TM1637, only two signal lines can make SCM four 8-segment LED.

Module features are as follows:

Display of male red for the four digital tube

Adjustable digital tube 8 gray

Level control interface for 5V or 3.3V

4 M2 screws positioning holes for easy installation


4 digital display interface module as shown below:




Control Interface: A total of four pins (GND, VCC, DIO, CLK), GND to ground, VCC is the power supply, DIO of data input and output pin, CLK is the clock signal pin;

Digital tube: 4 common anode score points with 0.36 inches LED, red highlights;

Positioning holes: 4 M2 screws positioning hole diameter is 2.2mm, the positioning of the module is easy to install, to achieve inter-module combination;